Allmatic-T-REX
Can be used horizontally.
Optimal for use on 5-axis machining centres.
Safe and fast clamping unmachined parts, flame-cut and sawn materials.
Clamping of parallel pre-machined workpieces with optional step jaws.
Suitable for materials of mechanical strength up to approx. 100 N/mm2.
Compact base and Generous clamping width.
Moulding and clamping in one working step, directly in the working area, no additional accessories required.
Rotatable movable jaw with pendulum design.
Gripper studs can be replaced without tools and are easy to adjust manually.
Use with torque wrench – max. 30 Nm.
Special Mechanical power-transfer device.
Jaw width 125 mm.
Allmatic-TITAN
Can be use horizontally
Also available in the TC TITAN version, which is suitable for horizontal machining centres.
Depending upon clamping jaws, both pre-machined and unmachined parts can be clamped.
Suitable for materials of mechanical strength up to approx. 1000 N/mm2.
Polished jaws to ensure precision needed for machining.
Used with torque wrench – max. 30 Nm.
Great Flexibility.
Enables machining work even in cases where clamping over a table is awkward.
Jaw width 125 mm.
Allmatic-DUO
For Horizontal and Lateral Use.
Clamping force preset in 4-6 increments.
Max clamping force in 2 revolutions.
For clamping of two identical parts (± 3.5mm).
Jaw width 90 and 125 mm.
Allmatic-CENTRO
Suitable for extremely heavy machining work and precision manufacture when used both horizontally and vertically.
Purely mechanical power intensification acts symmetrically on the clamping jaws.
Adjustable clamping force in 4 increments avoids deformation of the workpiece and increases precision of the workpiece position.
Adjustable centre shift for simple alignment of the neutral axis
Jaw width 125mm.
Allmatic-TC
Suitable for horizontal, vertical and lateral use.
Polished on all sides.
Superb Precision
Clamping force can be preset in 4-11 increments.
Maximum clamping force with 2 revolutions.
Jaw width 70, 90, 125, 160, 200 mm.